The key to the success of this system is its positional nature. For this reason, these numerals tend to be referred to as Hindu-Arabic numerals. System was in turn adopted by the Arabs, who ultimately transmitted it to Europe in the twelfth century. Our numerals have their origin in a system developed by the Hindu scholars of India in the middle of the first millennium AD. Fifteen hundred years of development have given us an extremely succinct method for writing down even very large numbers. ![]() (There is no connection between angle minutes & seconds and time minutes & seconds.The symbols 1, 2, 3, 4, 5, 6, 7, 8, 9, 0, are so commonplace that we rarely appreciate just how special our system of numerals really is. There are 60 minutes in a degree, and 60 seconds in one of these minutes. There are also 360 degrees in a circle (6 x 60), and a single degree can be broken down still further. There are 60 minutes in an hour, and 60 seconds in a minute. In fact, the Babylonians have given their base 60 to us. There are many factors (numbers which divide into it). You many wonder why they seemed to like the number sixty so much. It is a base 10 / base 60 system, and quite hard to understand. The Babylonians had a sophisticated number system, but it didn't quite work. You can also do arithmetic far easier, although I'm not quite sure about learning multiplication tables up to 60! But you do really need a zero. The great advantage of the positional system is that you need only a limited number of symbols (the Babylonians only had two, plus their symbol for zero) and you can represent any whole number, however big. He knows that there are large amounts of them, so a single one represents 3,600. Let's assume that a Babylonian is counting things. You could say that there should be a bigger gap for 3601, since the gap represents nothing in the sixty column, but how easy to make a mistake! So the Babylonians DID have a zero, which they used only in only in the middle of numbers. The number 3601 is not too different from 3660, and they are both written as two ones. However, it is more serious with gaps in the middle of the number. After all, if you were counting things, you would tend to know if you were counting individual things or counting in lots of sixty (or even 3,600!) So the Babylonians didn't bother with a zero at the end of the number. Believe it or not, this didn't worry them. The Babylonian symbol for one and sixty are the same. We use zero to distinguish between 10 (one ten and no units) and 1 (one unit). A careless clerk might make mistakes that way, but if you were careful, it should be all right.Ī more serious problem was that to start with they had no symbol for zero. But the representation of two has the two ones touching, while the representation for sixty one has a gap between them. You can now see why they piled the units up into neat piles! They needed to distinguish one plus one or two, from one times sixty plus one meaning sixty one. So the left-hand column were units, the second, multiples of 60, the third, multiplies of 3,600, and so on. The Babylonians had the same system, but they used powers of sixty rather than ten. ![]() Then you can add each column, carrying forward to the next, if necessary. If you want to add large numbers (and you've lost your calculator!) you line the numbers up so their units are in the same column. ![]() So the right hand column is units, the next is tens, the next is hundreds, and so on. We use a positional system, and our columns represent powers of ten. Were working their way towards a positional system (see below).Ī positional number system is one where the numbers are arranged in columns. Surely this is very confusing! However, the Babylonians Sixty one is sixty and one, which therefore looks Eleven was ten and one, twelve was ten and one and one, twenty was tenĪnd ten, just like the Egyptians. Were too many symbols, so they turned the stylus on its side to make a different They tended to arrange the symbols into neat piles. Ones to represent two, three ones for three, and so on, up to nine. Like the Egyptians, the Babylonians used two I am using a yellow background to represent the clay!Įnter a number from 1 to 99999 to see how the Babylonians would have written it, or enter a number to count with. This explains why the symbol for one was not just a single line, like most systems. The Babylonians writing and number system was done using a stylus which they dug into a clay tablet. It is quite a complicated system, but it was used by otherĬultures, such as the Greeks, as it had advantages It was developed from a number system belonging to a much older civilisationĬalled the Sumerians.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |